Xbee pro

Description The XBee-PRO 900 RF module is ideally suited for less power-hungry, low-latency point-to-multipoint networking applications. Capable of point-to-point, peer-to-peer and point-to-multipoint networking, The XBee-900 modules have a higher selectable transmitting power of 250mW. This higher Tx power allows for line-of-sight range up to 28 miles with the right antenna. It is ideal for solutions where RF penetration and absolute transmission distance are paramount to the application. As a member of the XBee family of RF products, the module is easy-to-use, shares a common footprint, and leverages Digi’s Drop-in Networking solutions including gateways and adapters. No configuration is necessary for out-of-the-box RF communications. The module’s default configuration supports a wide range of data system applications. Advanced configurations can be implemented using simple serial AT commands. 900MHz VS 2.4GHz Most of the Xbee modules operate at 2.4GHz, but there are a few that operate at 900MHz. Basically, 900MHz can go a lot farther with a high gain antenna (up to 15miles for the Pro modules and a high gain antenna). Also the lower the frequency the greater penetration the signal has. 900MHz is also not allowed in many countries (although there are 868MHz versions available from Digi that are allowed in many other countries). You can NOT mix and match these on the same network. Hardware Processor: ADF transceiver, Cortex-M3 EFM32G MHz Programmable includes: Freescale MC9S08QE32 Frequency Band： 902 to 928 MHz, software selectable channel mask for interference immunity Performance RF Data Rate： 10 Kbps or 200 Kbps Indoor/Urban Range： 10 Kbps: up to ft (610 m); 200 Kbps: up to ft (305 m) Outdoor/ Line-Of-Sight Range： 10 Kbps: up to 9 miles (14 km); 200 Kbps: up to 4 miles (6.5 km) (w/ 2.1 dB dipole antennas) Transmit Power： Up to 24 dBm (250 mW) software selectable Receiver Sensitivity： -101 dBm @ 200 Kbps, -110 dBm @ 10 Kbps Features Data Interface： UART (3V), SPI GPIO： Up to 15 Digital I/O, 4 10-bit ADC inputs, 2 PWM outputs Networking Topologies： DigiMesh, Repeater, Point-to-Point, Point-to-Multipoint, Peer-to-Peer Spread Spectrum： FHSS (Software Selectable Channels) Programmability Memory： N/A 32 KB CPU/Clock Speed： N/A Power Supply Voltage 2.1 to 3.6 VDC C Transmit Current 215 mA Receive Current 29 mA Sleep Current 2.5 uA Physical Properties Weight: 6.4g Size: 3.3cm x 2.5cm (4.5 x 2.5cm with connector) Antenna： RPSMA Package list: 1 x XBee PRO S3B RPSMA antenna" Box Pack - No Warranty

Description The XBee-PRO 900 RF module is ideally suited for less power-hungry, low-latency point-to-multipoint networking applications. Capable of point-to-point, peer-to-peer and point-to-multipoint networking, The XBee-900 modules have a higher selectable transmitting power of 250mW. This higher Tx power allows for line-of-sight range up to 28 miles with the right antenna. It is ideal for solutions where RF penetration and absolute transmission distance are paramount to the application. As a member of the XBee family of RF products, the module is easy-to-use, shares a common footprint, and leverages Digis Drop-in Networking solutions including gateways and adapters. No configuration is necessary for out-of-the-box RF communications. The modules default configuration supports a wide range of data system applications. Advanced configurations can be implemented using simple serial AT commands. 900MHz VS 2.4GHz Most of the Xbee modules operate at 2.4GHz, but there Box Pack - No Warranty

Description The XBee-PRO 900 RF module is ideally suited for less power-hungry, low-latency point-to-multipoint networking applications. Capable of point-to-point, peer-to-peer and point-to-multipoint networking, The XBee-900 modules have a higher selectable transmitting power of 250mW. This higher Tx power allows for line-of-sight range up to 28 miles with the right antenna. It is ideal for solutions where RF penetration and absolute transmission distance are paramount to the application. As a member of the XBee family of RF products, the module is easy-to-use, shares a common footprint, and leverages Digis Drop-in Networking solutions including gateways and adapters. No configuration is necessary for out-of-the-box RF communications. The modules default configuration supports a wide range of data system applications. Advanced configurations can be implemented using simple serial AT commands. 900MHz VS 2.4GHz Most of the Xbee modules operate at

Description The XBee-PRO 900 RF module is ideally suited for less power-hungry, low-latency point-to-multipoint networking applications. Capable of point-to-point, peer-to-peer and point-to-multipoint networking, The XBee-900 modules have a higher selectable transmitting power of 250mW. This higher Tx power allows for line-of-sight range up to 28 miles with the right antenna. It is ideal for solutions where RF penetration and absolute transmission distance are paramount to the application. As a member of the XBee family of RF products, the module is easy-to-use, shares a common footprint, and leverages Digis Drop-in Networking solutions including gateways and adapters. No configuration is necessary for out-of-the-box RF communications. The modules default configuration supports a wide range of data system applications. Advanced configurations can be implemented using simple serial AT commands. Box Pack - No Warranty

Features: 3.3V @ 215mA 250kbps Max data rate 60mW output (+18dBm) 1 mile (m) range Built-in antenna Fully FCC certified 6 10-bit ADC input pins 8 digital IO pins 128-bit encryption Local or over-air configuration AT or API command set Box Open - Never Used - No Warranty

Features: 3.3V at 215mA 250kbps Max data rate 60mW output +18dBm 1 mile m range Built-in antenna Fully FCC certified 6 10-bit ADC input pins 8 digital IO pins 128-bit encryption Local or over-air configuration AT or API command set" Facebook page;ElectronicsArena.com Box Pack - No Warranty

Features: 3.3V at 215mA 250kbps Max data rate 60mW output +18dBm 1 mile m range Built-in antenna Fully FCC certified 6 10-bit ADC input pins 8 digital IO pins 128-bit encryption Local or over-air configuration AT or API command set" Facebook page;ElectronicsArena.com

Features: 3.3V at 215mA 250kbps Max data rate 60mW output +18dBm 1 mile m range Built-in antenna Fully FCC certified 6 10-bit ADC input pins 8 digital IO pins 128-bit encryption Local or over-air configuration AT or API command set" Box Pack - No Warranty

features: 3.3v 215ma 250kbps max data rate 60mw output plus 18dbm 1 mile m range built in antenna fully fcc certified 6 10 bit adc input pins 8 digital io pins 128 bit encryption local or over air configuration at or api command set

features: 3.3v 215ma 250kbps max data rate 60mw output plus 18dbm 1 mile m range built in antenna fully fcc certified 6 10 bit adc input pins 8 digital io pins 128 bit encryption local or over air configuration at or api command set" Box Pack - No Warranty

Features 3.3V 215mA 250kbps Max data rate 60mW output 18dBm 1 mile m range Built-in antenna Fully FCC certified 6 10-bit ADC input pins 8 digital IO pins 128-bit encryption Local or over-air configuration AT or API command set Box Pack - No Warranty

Features 3.3V 215mA 250kbps Max data rate 60mW output 18dBm 1 mile 1500m range Built-in antenna Fully FCC certified 6 10-bit ADC input pins 8 digital IO pins 128-bit encryption Local or over-air configuration AT or API command set

WRL-11812 SPARKFUN This is a simple to use, USB to serial base unit for the Digi XBee line. This unit works with all XBee modules including the Series 1 and Series 2.5, standard and Pro version. Plug the unit into the XBee Explorer, attach a mini USB cable, and you will have direct access to the serial and programming pins on the XBee unit. The highlight of this board is an FT231X USB-to-Serial converter. That’s what translates data between your computer and the XBee. There’s also a reset button, and a voltage regulator to supply the XBee with plenty of power. In addition, there are four LEDs that’ll help if you ever need to debug your XBee: RX, TX, RSSI (signal-strength indicator), and power indicator. This board also breaks out each of the XBee’s I/O pins to a pair of breadboard-compatible headers. So if you want to make use of the XBee’s extended functionality, you can solder some header pins into those, or even just solder some wire. Now Buy Online Shipping All Across Pakistan COMPANY: MATRIX ELECTRONICS CONTACT PERSON: FAIZAN MUNIR Mobile:03002785860 www.matrixelectronic.com Email : sales@matrixelectronic.com Email : info@matrixelectronic.com

WRL- SPARKFUN This is a simple to use, USB to serial base unit for the Digi XBee line. This unit works with all XBee modules including the Series 1 and Series 2.5, standard and Pro version. Plug the unit into the XBee Explorer, attach a mini USB cable, and you will have direct access to the serial and programming pins on the XBee unit. The highlight of this board is an FT231X USB-to-Serial converter. That’s what translates data between your computer and the XBee. There’s also a reset button, and a voltage regulator to supply the XBee with plenty of power. In addition, there are four LEDs that’ll help if you ever need to debug your XBee: RX, TX, RSSI (signal-strength indicator), and power indicator. This board also breaks out each of the XBee’s I/O pins to a pair of breadboard-compatible headers. So if you want to make use of the XBee’s extended functionality, you can solder some header pins into those, or even just solder some wire. Now Buy Online Shipping All Across Pakistan COMPANY: MATRIX ELECTRONICS CONTACT PERSON: FAIZAN MUNIR Mobile: www.matrixelectronic.com Email: Email: Box Pack- Warranty: 1 Months

WRL-12847 SparkFun XBee Shield Description: Xbee radios are an awesome way to add wireless capability to your Arduino project and now it’s even easier with the XBee Shield. The shield form-factor mates directly with any dev board that has an Arduino standard footprint and equips it with wireless communication capabilities using the popular XBee module. This unit works with all XBee modules including the Series 1 and 2, standard and Pro versions. WRL 12847 XBee Shield SPARKFUN Now Buy Online Shipping All Across Pakistan COMPANY: MATRIX ELECTRONICS CONTACT PERSON: FAIZAN MUNIR Mobile:03002785860 www.matrixelectronic.com Email : sales@matrixelectronic.com Email : info@matrixelectronic.com

WRL- SparkFun XBee Shield Description: Xbee radios are an awesome way to add wireless capability to your Arduino project and now it’s even easier with the XBee Shield. The shield form-factor mates directly with any dev board that has an Arduino standard footprint and equips it with wireless communication capabilities using the popular XBee module. This unit works with all XBee modules including the Series 1 and 2, standard and Pro versions. WRL XBee Shield SPARKFUN Now Buy Online Shipping All Across Pakistan COMPANY: MATRIX ELECTRONICS CONTACT PERSON: FAIZAN MUNIR Mobile: www.matrixelectronic.com Email: Email: Box Pack - No Warranty

WRL-11373 Original SparkFun in very cheap rates Description: The XBee Explorer Regulated takes care of the 3.3V regulation, Signal conditioning,and basic activity indicators (Power, RSSI and DIN/DOUT activity LEDs). It translates the 5V serial signals to 3.3V so that you can connect a 5V (down to 3.3V) system to any XBee module.WRL-11373 board was conveniently designed to mate directly with Arduino Pro boards for wireless bootloading and USB based configuration. This unit works with all XBee modules including the Series 1 and 2, standard and Pro versions. Plug an XBee into this breakout and you will have direct access to the serial and programming pins on the XBee unit and will be able to power the XBee with 5V. This board comes fully populated with 3.3V regulator (16V max input), XBee socket, four status LEDs, and level shifting. WRL-11373 Original SparkFun latest revision the diode level shifter is replaced with a more robust MOSFET level shifter. This board does not include and XBee module. XBee modules sold below. Now Buy Online Shipping All Across Pakistan COMPANY: MATRIX ELECTRONICS CONTACT PERSON: FAIZAN MUNIR Mobile:03002785860 www.matrixelectronic.com Email : sales@matrixelectronic.com Email : info@matrixelectronic.com

WRL-09819 Original SparkFun Description: This is the XBee Explorer Dongle unit for the XBee line. With the XBee Explorer dongle you can now plug the unit directly into your USB port. No cables needed! This unit works with all XBee modules including the Series 1 and Series 2.5, standard and Pro version. The on-board voltage regulator is good up to 500mA. Now Buy Online Shipping All Across Pakistan COMPANY: MATRIX ELECTRONICS CONTACT PERSON: FAIZAN MUNIR Mobile:03002785860 www.matrixelectronic.com Email : sales@matrixelectronic.com Email : info@matrixelectronic.com

WRL- Original SparkFun Description: This is the XBee Explorer Dongle unit for the XBee line. With the XBee Explorer dongle you can now plug the unit directly into your USB port. No cables needed! This unit works with all XBee modules including the Series 1 and Series 2.5, standard and Pro version. The on-board voltage regulator is good up to 500mA. Now Buy Online Shipping All Across Pakistan COMPANY: MATRIX ELECTRONICS CONTACT PERSON: FAIZAN MUNIR Mobile: www.matrixelectronic.com Email: Email: Box Pack - No Warranty