NEUMANN TLM 103MT BLACK LARGE-DIAPHRAGM CONDENSER MICROPHONE IN KARACHI

Extremely low self-noise and the high SPL transmission! A standard name in high-end recording studios around the world, Neumann mics deliver the professional touch that’s needed to capture high-quality audio. The TLM 103 is fast becoming a standard for home recording and the music industry. The large-diaphragm Neumann TLM-103 Microphone provides platinum-quality sound on a bronze budget, using transformerless circuitry for ultralow self-noise and handling high sound pressure levels up to 138dB. The TLM-103’s cardioid polar pattern optimizes attenuation of unwanted sound and suppresses feedback and comes with a rugged wire mesh grille that helps protect the capsule. This is the mic for everyone who, despite budget limitations, does not want to do without the uncompromising Neumann sound. It's not just for vocals -- the versatile Neumann TLM 103 studio microphone will let your voiceovers, guitars, and other acoustic instruments shine with "that Neumann sound" which draws audio professionals to the brand time and time again. The affordable TLM 103 is a large-diaphragm cardioid microphone featuring a transformerless circuit, low noise, high sound pressure level (SPL) handling, and a capsule based on the company's classic, significantly more expensive U87 capsule. This large-diaphragm condenser mic will do the job for a range of applications, from home recording to professional broadcasting and commercial recording studio use. Cardioid: An Excellent Choice for Most Recording Situations The TLM 103 boasts a large-diaphragm capsule with a universal cardioid pattern that draws in sound at the front of the microphone and rejects sound from the rear. When capturing vocals, recording instruments like the acoustic guitar, doing interviews, and so forth, a cardioid mic is often the way to go. With this Neumann microphone, off-axis sounds are rendered naturally while isolation is increased. Looks and Sounds Like a Neumann Its K 103 large-diaphragm capsule, based on the K 87 from the company's U 67 and U 87 microphones, has a flat frequency response up to about 4 kHz, and above that, a wide 4 dB presence boost. So that you know it's a Neumann, the TLM 103 is addressed from the front and is marked with the red Neumann logo on the body of the microphone. The microphone keeps plosives, pops, and other unwanted noises in check, thanks to its large wire mesh headgrille, which protects the capsule. You can use a pop filter with the TLM 103 if you want, but you may not really need it unless you are exceptionally spitty when you sing or speak. To further prevent noise from interfering with the mic's performance, the TLM 103's entire internal construction is elastically mounted. What's more, the capsule is set on an elastic mount. Since its frequency range actually reaches below 20 Hz, the lowest of low bass signals are reproduced without coloration. It's because of this low frequency extension that the TLM 103 is more sensitive to structure-borne interference and wind noise. Features Large diaphragm cardioid microphone Pressure gradient transducer with with one-diaphragm capsule Transformerless circuitry Extremely low noise: 7 dB-A Includes swivel mount Straightforward handling for homerecording and professional studios TLM 103 Microphone Specifications: Acoustical operating principle Pressure gradient transducer Directional pattern Cardioid Frequency range 20 Hz... 20 kHz Sensitivity at 1 kHz into 1 kohm 23 mV/Pa Rated impedance 50 ohms Rated load impedance 1 kohms Equivalent noise level, CCIR1) 17.5 dB Equivalent noise level, A-weighted1) 7 dB-A Signal-to-noise ratio, CCIR1) (rel. 94 dB SPL) 76.5 dB Signal-to-noise ratio, A-weighted1) (rel. 94 dB SPL) 87 dB Maximum SPL for THD 0.5%2) 138 dB Maximum output voltage 13 dBu Dynamic range of the microphone amplifier (A-weighted) 131 dB Supply voltage (P48, IEC 61938) 48 V ± 4 V Current consumption (P48, IEC 61938) 3 mA Matching connector XLR3F Weight approx. 450 g Diameter 60 mm Length 132 mm Views: 2