MINI OSD V1.1 WITH CASE IN ISLAMABAD

This is a mini Arduino based on-screen display board. It's tailored for use with ArduPilot Mega and the MAVlink protocol, and designed to be as small as possible. It's main components are an ATmega328P 8 bit microcontroller with an Arduino bootloader, and a MAX7456 monochrome on-screen display. Programming is done through an FTDI-compatible 6-pin cable. MinimOSD is companion On Screed Display (OSD) Board for APM. It reads all the MAVLink data in the APM telemetry stream and overlays it on the video stream if you're using an on-board camera and wireless video transmitter. This is useful if you're flying in First Person View (FPV) mode or don't want to use a laptop at the field to see your telemetry data in the Mission Planner. Features Two independent power and ground sections to isolate the OSD's analog stage: A +5V section for the ATmega and the OSD's digital stage, powered through the FTDI cable or other +5V source A regulated +5V section for the OSD's analog stage, powered through the video in/out header and capable of handling up to +12V input. Solder jumpers are available to combine the two power and ground sections if desired. Supports APM2, APM2.5, APM2.6 Technical Specifications ATmega328P with Arduino bootloader MAX7456 monochrome on-screen display chip. FTDI cable compatible pinout Standard 6-pin ISP header (Not Populated) Two independent power sections with an LED indicator on each Solder jumpers for combining the power sections +5V 500mA regulator for up to +12V supply input Solder jumper for PAL video option Exposed test points for HSYNC and LOS Dimensions: 0.7"W x 1.7"L (2.4" w/ pins as shown) x 0.3"H Documents and Downloads MAX7456 Datasheet MinimOSD - Basic wiring Diagram Scheme An example connection Scheme by Jason Eric Anderson MinimOSD video Package Includes 1x Minim OSD v1.1 module with plastic casing A set of female to female cables