CAR WINDSHIELD REPAIR KIT TOOLS AUTO GLASS WINDSCREEN REPAIR IN PAKISTAN

Cash On Delivery service available all over Pakistan Features: Allows anyone to fix a damaged windshield or window. Single ingredient - eliminates mixing. Creates an invisible, undetectable repair in damaged automobile windshields or other laminated glass for windows.（Includes instructions.） DIY windshield repair kit is designed to fill the air cavity with a strong penetrating adhesive that will bond the loose glass and restore the visibility. The patented design evacuates the air to fill the cavities with specially formulated liquid glass, that distortion and bonds the loose glass preventing the damage from spreading. Windshield repair instructions 1, Clean damaged area Clean out any loose glass particles from PIT (hole caused by striking object) of the break using Pin from injector. Replace PIn after use. Clean area surrounding break a dry cloth or paper towel 2, Mount seal t windshield PEEL backing off side of adhesive seal Line up hole in seal with PIT (Pointing tab upward) Press seal to glass. Run fingers around seal to insure a good bond. 3, Remove backing from seal Peel backing from top side of adhesive seal. 4, Mount pedestal to adhesive seal Line up pedestal with adhesive seal making sure tabs match up. Press pedestal to glass. Run fingers to insure a tight bond. 5, Place resin into pedestal Cut tip off resin container to open stem. Place stem 1/4 inch into pedestal opening. Slowly squeeze 5 to 6 drops into pedestal. Wipe any excess resin from tip with & save the empty container for step 11. 6, Connect injector to pedestal Insure plunger tip is positioned in injector barrel just above the PIN valve. Press fit injector into pedestal with the PIN valve lined up with the tab. Insure connection is tight. 7, Lock plunger in vacuum position Hold injector with one hand,pull plunger upward with the other hand. Lock plunger by engaging lower notch in plunger with spring clip. Release hands and allow device to remain in locked postion. 8, Fill injector with air Take injector out from the pedestal, make the plunger to its maxi postion Put the injector back to the pedestal. 9, Move plunger to pressure Hold injector with one hand and rotate plunger releasing spring clip from lower notch. Depress plunger downward engage upper notch with spring clip. 10, Remove pedestal from glass Loose outer edges of pedestal with a safety razor. Once top part of pedestal and seal is bent away from glass surface, grip pedestal tab as show. Slowly pull up until removed. Wipe and remove excess resin. 11, Pit Filling procedure Hold resin container in once hand and make ready the clear for repair film in the other hand as shown. Slowly squeeze resin container applying a drop of resin in PIT. Place clear repair film over PIT holding resin in the PIT.